CVE-2026-72121: can: bcm: add locking when updating filter and timer values

Severity: high (CVSS 8.8 v3.1)
Exploited in the wild: not listed in CISA KEV
EPSS: 0.4% probability of exploitation in the next 30 days
Public exploit or detection template: none known
Published: 2026-08-15 · updated 2026-10-16

Description

In the Linux kernel, the following vulnerability has been resolved: can: bcm: add locking when updating filter and timer values KCSAN detected a simultaneous access to timer values that can be overwritten in bcm_rx_setup() when updating timer and filter content while bcm_rx_handler(), bcm_rx_timeout_handler() or bcm_rx_thr_handler() run concurrently on incoming CAN traffic. Protect the timer (ival1/ival2/kt_ival1/kt_ival2/kt_lastmsg) and filter (nframes/flags/frames/last_frames) updates in bcm_rx_setup() with a new per-op bcm_rx_update_lock, taken with the matching scope in the RX handlers. memcpy_from_msg() is staged into a temporary buffer before the lock is taken, since it can sleep and must not run under a spinlock. hrtimer_cancel() is always called without bcm_rx_update_lock held, since bcm_rx_timeout_handler()/bcm_rx_thr_handler() take the same lock and a running callback would otherwise deadlock against the canceller. Also close a related race: bcm_rx_setup() cleared the RTR flag in the stored reply frame's can_id as a separate, unprotected step after the frame content was already installed, so a concurrent bcm_rx_handler() could transmit a stale reply with CAN_RTR_FLAG still set. Fold that normalization into the initial frame preparation instead (on the staged buffer for updates, directly on op->frames pre-registration for new ops), so the installed frame is always atomically self-consistent. bcm_rx_handler()'s RX_RTR_FRAME check now takes a lock-protected snapshot of op->flags before deciding whether to call bcm_can_tx(), but does not hold the lock across that call. Also take a lock-protected snapshot of the currframe in bcm_can_tx() to avoid partly overwrites by content updates in bcm_tx_setup(). Finally check if a TX_RESET_MULTI_IDX/SETTIMER might have reset op->currframe between the two locked sections in bcm_can_tx(). Omit calling hrtimer_forward() with zero interval in bcm_rx_thr_handler(). kt_ival2 may have been concurrently cleared by bcm_rx_setup() before it cancels this timer, so check kt_ival2 inside the bcm_rx_update_lock.

Affected products

Linux kernel: from 5.10.238 before 5.10.265; from 5.15.185 before 5.15.216; from 6.1.141 before 6.1.183; from 6.6.93 before 6.6.148; from 6.12.31 before 6.12.101; from 5.4.294 before 5.5 — fixed in 5.10.265, 5.15.216, 5.5, 6.1.183, 6.12.101, 6.15

How to fix

Upgrade to a fixed version: Linux kernel 5.10.265, 5.15.216, 5.5, 6.1.183. Check the vendor advisory for mitigations.

References

Get alerted when CVE-2026-72121 or the next vulnerability affects your stack