CVE-2026-93123: serial: qcom-geni: do not advance stale DMA completions

Severity: unknown
Exploited in the wild: not listed in CISA KEV
EPSS: 0.2% probability of exploitation in the next 30 days
Public exploit or detection template: none known
Published: 2026-09-17 · updated 2026-10-19

Description

In the Linux kernel, the following vulnerability has been resolved: serial: qcom-geni: do not advance stale DMA completions The qcom GENI serial DMA TX completion path advances the transmit fifo by the number of bytes recorded in port->tx_remaining. If uart_flush_buffer() runs after the hardware has completed a DMA transfer but before the DMA completion interrupt has been handled, the serial core resets the transmit fifo while port->tx_remaining still describes the old DMA transfer. A previous fix avoided advancing an empty fifo by checking that the fifo length is at least tx_remaining. That still does not distinguish the old DMA payload from new bytes written after the flush. If userspace writes new data before the stale DMA completion interrupt is handled, the fifo can again contain at least tx_remaining bytes and the stale completion can advance and discard those new bytes. Mark an in-flight DMA transfer stale when the transmit fifo is flushed. The later completion still unprepares the original DMA mapping using the saved length, but it no longer advances the transmit fifo.

Affected products

Linux kernel: 6.3 — fixed in 7.3

How to fix

Upgrade to a fixed version: Linux kernel 7.3. Check the vendor advisory for mitigations.

References

Get alerted when CVE-2026-93123 or the next vulnerability affects your stack